AXL E EIP DI16 M12 6P

https://www.phoenixcontact.com/pi/products/2701493 Distributed I/O device - AXL E EIP DI16 M12 6P - 2701493 Please be informed that the data shown in this PDF Document is generated from our Online Catalog. Please find the complete data in the user's documentation. Our General Terms of Use for Downloads are valid (http://phoenixcontact.com/download) Axioline E EtherNet/IP™ device in a plastic housing with 16 digital inputs, 24 V DC, M12 fast connection technology Why buy this product ■ ■ ■ ■ ■ ■ Connection to EtherNet/IP™ network using M12connectors (D-coded) Transmission speed of 10 Mbps and 100 Mbps Connection of digital sensors using M12connectors (A-coded) Diagnostic and status indicators Short-circuit and overload protection of the sensor supply IP65/IP67 degree of protection Key Commercial Data Packing unit 1 STK GTIN Technical data Note Utilization restriction EMC: class A product, see manufacturer's declaration in the download area Dimensions Width 60 mm Height 185 mm Depth 30.5 mm Note on dimensions The height is 212 mm including fixing clips. Drill hole spacing 198.5 mm Ambient conditions Ambient temperature (operation) -25 °C ... 60 °C Ambient temperature (storage/transport) -25 °C ... 85 °C Permissible humidity (operation) 5 % ... 95 % Permissible humidity (storage/transport) 5 % ... 95 % 03/09/2016   Page 1 / 5 https://www.phoenixcontact.com/pi/products/2701493 Distributed I/O device - AXL E EIP DI16 M12 6P - 2701493 Technical data Ambient conditions Air pressure (operation) 70 kPa ... 106 kPa (up to 3000 m above sea level) Air pressure (storage/transport) 70 kPa ... 106 kPa (up to 3000 m above sea level) Degree of protection IP65/IP67 General Net weight 547 g Mounting type Wall mounting Interfaces Fieldbus system EtherNet/IP™ Designation EtherNet/IP™ Connection method M12-Schnellanschlusstechnik Note on connection method D-coded Designation connection point Copper cable Transmission speed 10/100 MBit/s (with auto negotiation) Number of positions 4 System limits of the bus coupler Designation EtherNet/IP™ Equipment type EtherNet/IP™ slave System-specific protocols EtherNet/IP™ protocols ACD EtherNet/IP™ protocols DLR EtherNet/IP™ protocols IGMP v2 Protocols supported SNMP v1 HTTP TFTP FTP BootP DHCP Specification CIP Edition 3.11 EIP adaptation of CIP 1.12 Power supply for module electronics Module electronics and sensors M12 connector (T-coded) Module electronics and sensors (US) 4 Connection method M12 connector (T-coded) Designation Module electronics and sensors (US) Number of positions 4 Supply voltage 24 V DC Nominal supply voltage range 18 V DC ... 31.2 V DC (including all tolerances, including ripple) Current consumption max. 12 A Typical current consumption 190 mA ±15 % (at 24 V DC) Actuators M12 connector (T-coded) Actuators (UA) for additional devices 4 Connection method M12 connector (T-coded) 03/09/2016   Page 2 / 5 https://www.phoenixcontact.com/pi/products/2701493 Distributed I/O device - AXL E EIP DI16 M12 6P - 2701493 Technical data Power supply for module electronics Designation Actuators (UA) for additional devices Number of positions 4 Supply voltage 24 V DC Nominal supply voltage range 18 V DC ... 31.2 V DC (including all tolerances, including ripple) Current consumption max. 12 A Typical current consumption 3 mA ±15 % (at 24 V DC) Digital inputs Input name Digital inputs Description of the input EN 61131-2 types 1 and 3 Connection method M12 connector, double occupancy 4-wire Number of inputs 16 Protective circuit Overload protection, short-circuit protection of sensor supply Input filter time < 1000 µs Input voltage range "0" signal -30 V DC ... 5 V DC Input voltage range "1" signal 11 V DC ... 30 V DC Nominal input current at UIN typ. 3 mA Standards and Regulations Conformity with EMC directives Noise immunity test in accordance with EN 61000-6-2 Electrostatic discharge (ESD) EN 61000-4-2/IEC 61000-4-2 Criterion B, 6 kV contact discharge, 8 kV air discharge Noise immunity test in accordance with EN 61000-6-2 Electromagnetic fields EN 61000-4-3/IEC 61000-4-3 Criterion A; Field intensity: 10 V/m Noise immunity test in accordance with EN 61000-6-2 Fast transients (burst) EN 61000-4-4/IEC 61000-4-4 Criterion B, 2 kV Noise immunity test in accordance with EN 61000-6-2 Transient overvoltage (surge) EN 61000-4-5/IEC 61000-4-5 Criterion B, DC supply lines: ±0.5 kV/±0.5 kV (symmetrical/asymmetrical) Noise immunity test in accordance with EN 61000-6-2 Conducted interference EN 61000-4-6/IEC 61000-4-6 Criterion A; Test voltage 10 V Noise emission test as per EN 61000-6-4 Radio interference properties EN 55022 Class A Test section 24 V supply (communications power and sensor supply, digital inputs)/ bus connection (Ethernet 1) 500 V AC 50 Hz 1 min. 24 V supply (communications power and sensor supply, digital inputs)/ bus connection (Ethernet 2) 500 V AC 50 Hz 1 min. 24 V supply (communications power and sensor supply, digital inputs)/ FE 500 V AC 50 Hz 1 min. Bus connection (Ethernet 1)/FE 500 V AC 50 Hz 1 min. Bus connection (Ethernet 2)/FE 500 V AC 50 Hz 1 min. Bus connection (Ethernet 1)/bus connection (Ethernet 2) 500 V AC 50 Hz 1 min. 24 V supply (actuator supply)/24 V supply (communications power and sensor supply, digital inputs) 500 V AC 50 Hz 1 min. 03/09/2016   Page 3 / 5 https://www.phoenixcontact.com/pi/products/2701493 Distributed I/O device - AXL E EIP DI16 M12 6P - 2701493 Technical data Standards and Regulations 24 V supply (actuator supply)/bus connection (Ethernet 1) 500 V AC 50 Hz 1 min. 24 V supply (actuator supply)/bus connection (Ethernet 2) 500 V AC 50 Hz 1 min. 24 V supply (actuator supply)/FE 500 V AC 50 Hz 1 min. Mechanical tests Vibration resistance in acc. with EN 60068-2-6/IEC 60068-2-6 5g Shock in acc. with EN 60068-2-27/IEC 60068-2-27 30g, 11 ms period, half-sine shock pulse Continuous shock according to EN 60068-2-27/IEC 60068-2-27 10g Protection class III, IEC 61140, EN 61140, VDE 0140-1 Classifications eCl@ss eCl@ss 4.0 27240404 eCl@ss 4.1 27240404 eCl@ss 5.0 27242204 eCl@ss 5.1 27242604 eCl@ss 6.0 27242604 eCl@ss 7.0 27242604 eCl@ss 8.0 27242604 eCl@ss 9.0 27242604 ETIM ETIM 2.0 EC001433 ETIM 3.0 EC001599 ETIM 4.0 EC001599 ETIM 5.0 EC001599 UNSPSC UNSPSC 6.01 43172015 UNSPSC 7.0901 43201404 UNSPSC 11 39121311 UNSPSC 12.01 39121311 UNSPSC 13.2 39121311 Approvals Approvals Approvals UL Listed / cUL Listed / cULus Listed 03/09/2016   Page 4 / 5 https://www.phoenixcontact.com/pi/products/2701493 Distributed I/O device - AXL E EIP DI16 M12 6P - 2701493 Approvals Ex Approvals UL Listed / cUL Listed / cULus Listed Approvals submitted Approval details UL Listed  cUL Listed  cULus Listed  Drawings Connection diagram Dimensional drawing 212 IN 6 +24 V 30,5 IN 5 185 IN 12 198,5 60 30 IN 11 +24 V Phoenix Contact 2016 © - all rights reserved http://www.phoenixcontact.com PHOENIX CONTACT GmbH & Co. KG Flachsmarktstr. 8 32825 Blomberg Germany Tel. +49 5235 300 Fax +49 5235 3 41200 http://www.phoenixcontact.com 03/09/2016   Page 5 / 5